Retrotec DM-2A Manual do Utilizador descarregar pdf (Página 28)

Page 28 of 66

©Retrotec Inc. 2012

Full Screen Timeout

DM-2s that have firmware Version 3.0 or higher, have a large format screen, which automatically

appears when no key press is recorded for a period of time. The length of time that must pass is

determined by the Full Screen Timeout setting.

To change the Full Screen Timeout time period

1. Press [Setup] to access the Setup menu.

2. Press [] or [] to select "Full Screen Timeout" in the list. Press [Enter].

3. Input a time (in seconds) between 0-120. Press [Enter]. Press [Exit].

The DM-2 will not display the large format screen if a time period of '0' is used.

Restore Settings

At any time, the factory settings can be restored in the DM-2. This will reset the gauge to have exactly

the same settings that the gauge was shipped with.

To restore the factory settings

1. Press [Setup] to access the Setup menu.

2. Press [] or [] to select "Restore Settings" in the list.

3. Press [] or [] to select Yes.

Language

The DM-2 can display information in the following languages: English, French, German, Norwegian,

Swedish, and Latvian.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 65 66

Sem comentários

Retrotec DM-2A Manual do Utilizador Página 28