Retrotec DucTester 200 series with DM32 Manual do Utilizador

QG131 Page 1 of 8 rev-2015-01-21QuickGuide 241/242 DucTesterFlex DuctDM32 gauge(Battery

Make sure DucTester 240 is showing on the Home screen with “Mid” Range.If not, tap the fan picture, then Tap , tap DucTester 240, thenthe

□ Go to Home screen on gauge. □ Adjust fan speed knob clockwise until [Channel A] reaches test pressure. □ If not possible, go to Step

Flow at the induced pressure is the simplest result. (Also available in metric units).Flow per square foot is required in some states such as WA. (E

Page 5 of 8Check out Retrotec’s YouTube page, with all the videos you’ll need to help you setup, run, or trouble-shoot your equipment!● Visit our supp

Page 6 of 8To measure the air leakage from the duct system to outdoors requires both a DucTester and a Blower Door system. The Door Fan depressurizes

□ Connect Flex Duct to fan exhaust.□ Check that tubing is connected the same as for depressurize test (step 3).□ Conduct test (step 4).Duct Leaka

Tubing Accessory Kit35 ft (10 m) of blue, red, yellow and green 1/4 inch (12mm) outside diameter tubing. Static Pressure Probe, 4 inch (100 mm) x 1/8